Adhesive welding glue for rigid PVC-50, 500 ml

Adhesive that is very easy to apply and provides strong joints that are resistant to attack by aggressive products and ageing. It complies with UNE-EN 14814 and UNE-UN 14680 standards. It is a welding adhesive for joining rigid PVC pipes and materials, of particular interest for PRESSURE systems. Clean and degrease the surfaces to be glued. Apply a thin, uniform layer of adhesive to the sleeve and then a thicker layer to the end of the previously bevelled pipe. Immediately make the joint without turning. Remove excess adhesive with a cloth. The joint must not be subjected to stress or movement before the first 10 minutes. Depending on the ambient temperature and the aeration of the joint, the adhesive sets approximately 4 hours after its application. In installations that must withstand pressures greater than 1.5 atm, wait at least 24 hours before putting them into service. The bonding strength can be estimated up to the breaking of the material and not of the joint. It is a FLAMMABLE product. Therefore, good ventilation must be provided in the workplace and any possibility of sparks or fire must be avoided. For more information, consult the Safety Data Sheet.

Product Features:

• Easy to apply adhesive
• Resistant to attack by aggressive products
• Complies with UNE-EN 14814 and UNE-UN 14680 standards
• Ideal for PRESSURE systems

Frequently Asked Questions:

How should the adhesive be applied?
Apply a thin, even layer to the sleeve and a thicker layer to the previously beveled end of the tube.

How long does it take for the adhesive to set?
The adhesive sets approximately 4 hours after application, depending on the ambient temperature and aeration of the joint.

What precautions should I take when using this product?
It is important to have good ventilation in the workplace and avoid possible sparks or fires because the product is flammable.

How long should I wait before putting the installations into service?
In installations that must withstand pressures greater than 1.5 atm, it is recommended to wait at least 24 hours before putting them into service.

What standards does this welding adhesive comply with?
It complies with UNE-EN 14814 and UNE-UN 14680 standards to guarantee its quality and resistance in rigid PVC joints.