1" Automatic Pipe Suction Cup | Air Extraction and Irrigation Network Protection

In irrigation systems, distribution networks, or hydraulic systems, air accumulation in pipes can cause significant problems: reduced flow, vibrations, water hammer, overpressure, and even structural damage. With this 1" automatic air vent, you can install an air purge device at critical points in the network (usually at high elevations or slopes) to extract accumulated air and keep the system operating perfectly. Its robust body, standard 1" connection, and automatic operation make it suitable for gardens, orchards, swimming pools, or domestic/professional irrigation systems that require reliability. Invest in peace of mind, performance, and a long life for your hydraulic system.

Product Features:

• Automatically eliminates air pockets: This 1" air vent is designed to expel trapped air from pipes, preventing flow loss, vibrations, and failures in your irrigation or hydraulic system. A key accessory for efficiency.

• Easy installation on standard 1″ (≈ 25 mm) pipes: With a standard 1″ thread, it easily connects to your pipe network and can be placed at high points, changes in slope, or at risk areas. Ideal for garden, orchard, or pool systems.

• Water hammer and overpressure protection: Air and vacuum buildup in pipes can lead to dangerous overloads. This automatic air vent helps prevent these unwanted effects, keeping the network stable.

• Durable and Reliable Design: Made of materials suitable for outdoor environments, the suction cup withstands typical hydraulic pressure, continuous use, and ensures a tight seal to bleed air without water loss.

• Improves the health of your irrigation system: By removing air and maintaining a smooth water flow, you optimize system efficiency, save pumping energy, and extend the life of your entire plumbing system.

Frequently Asked Questions:

• What is a suction cup used for in a piping system?
  It is used to eliminate accumulated air inside the pipes, preventing pressure loss, noise, and water hammer.

• Where should the 1″ suction cup be installed?
  At the highest points in the system or where air may accumulate, such as changes in slope or long sections of pipe.

• Is the 1″ connection standard?
  Yes. The 1″ thread (approx. 25 mm) is a standard size, compatible with most irrigation pipes and domestic or professional hydraulic networks.

• Does it need maintenance or cleaning?
  It operates automatically and requires little maintenance. It's only recommended to periodically check for obstructions.

• On which systems can this suction cup be used?
  It is ideal for irrigation systems, agricultural facilities, drinking water networks, swimming pools, tanks or pressurized pipes.